Всем необходимо обновить JAF USB драйвера. http://files.odeon.cn/jaf%20usb%20driver_ver2.0.rar
Это необходимо для повышения стабильности работы JAF-бокса.
К тому же это понадобится для работы следующей версии JAF программы.
Всем необходимо обновить JAF USB драйвера. http://files.odeon.cn/jaf%20usb%20driver_ver2.0.rar
Это необходимо для повышения стабильности работы JAF-бокса.
К тому же это понадобится для работы следующей версии JAF программы.
Скочайте дрова с супорта заново в прошлых была
не поладка.
С ув.Руслан:)
New JAF ver 1.97 beta1
--------------------------------------------------------------------------------
Hi
Finaly new jaf version is ready, 1.97 beta1.
- added LCK option in bb5 flashing. This will autosave, if checked, the lock data from pm. If something goes wrong in flashing and phone will lock itself you can restore the lock data by writing pm back
- added 128k page flash chip support on usb flashing (6280, 6233 etc). Remember to use version 3.81 or higher to flash 6280 with AMD chips.
- improved usb communication. This will affect all bb5 and ape usb flashing.
- Improved File Sys detection. Now all should be ok. If still have problems please post.
- corrected 7710 ape usb flashing. It was due too short timeout on usb.
- added OMAP mcu check when flash phones with bad ape mcu. Flash will not start, saving the phone from erasing then error on write.
- added more error messages to improve hw error detection more easy
- and the SMALL SURPRISE: JAF NOW SUPPORTS UFS INTERFACE AS FLASHING INTERFACE. DCT4 and BB5 (5 or 7 pins cable) are fully supported for now. Soon more will follow. This is a beta stage. We are waiting for your feedback.
С этим обновлением Джаф потдерживает интерфейс UFS-а с DCT4 и BB5.
Теперь не будет проблем с кобелями 5 или 7 пинов.
При запуске проги она спросит у вас через какой интерфейс
вы хотите роботать если конечно подсоедены два бокса,выбераем
JAF или UFS и все.
http://files.odeon.cn/JAF_Main_Softw...eta1public.rar
Regards
ODEON TEAM
New JAF Ver 1.97 beta2
--------------------------------------------------------------------------------
Hi
New JAF 1.97 beta2 ready.
- added checked values by default for RPL208 and LCK308 flashing options. This may helps some users to prevent damaging the phones.
- fixed bug when you have no interface connected, clicking mode tabs will generate errors
- fixed a bug with File System detection, File2 was detected instead of SymbianEPOC. Still waiting for tests.. hope to be the last one.
- added DCT4 Erase flash support for UFS interface. Also fixed a bug with flash erase when fails even when flashing all was ok.
- added DCT4 imei patch support for UFS interface
- added DCT4 read flash support for UFS interface
- fixed some error messages not to popup.
- fixed some bugs when booting bb5 phones with UFS interface
http://files.odeon.cn/JAF_Main_Softw...AF197beta2.rar
Regards
ODEON TEAM
Качаем новую beta3
Тут : http://files.odeon.cn/JAF_Main_Softw...AF197beta3.rar
Качаем новые FIA
Тут : http://files.odeon.cn/Flash6.23.023.rar
Для работы ver 1.97 beta3 необходимо обновить FW бокса
Новшества :
- added PHONE TYPE display in top of the window when you read info, use ini.. etc
- added support for multi pkey flash. If you have more than one pkey you can use all for multiflash. You can use as many jaf or ufs interfaces you have.
- added BB5 life time reset FBUS/USB mode
- corrected error when changing tabs in PKEY only mode
- added Read PP in dct4/bb5 FBUS/USB
- added MAKE INI in manual mode
- added dct4 simlock data info
- added 128k flash for bb5 USB mode (tested 6280 3.81 and 6233 3.70)
- improved simlock for dct4. 1600 5.03 direct unlock still not supported but it will be ready soon.
- added support for fia 6.23.023 for ufs interface.
Update's выходят с бешенной скоростью.
Успеваем качать : http://files.odeon.cn/JAF_Main_Softw...AF197beta4.rar
Новшество - одно
- fixed bug in bb5 usb ape flashing. No detection of the phone in boot mode.
Очередная версия 1.97 beta5
ТУТ : http://files.odeon.cn/JAF_Main_Softw...AF197beta5.rar
Изменения :
- fixed bug with pkey only when change tab. Hope for good.
- enabled asking when RPL208 or LCK308 can't be saved
- manual don't disable now RPL208 and LCK308
- improved msg id detection causing error on cdma/tdma phones
New JAF ver 1.97 beta6
Эту НЕ КАЧАЕМ , она почти НЕРАБОЧАЯ !!!
--------------------------------------------------------------------------------
New JAF ver 1.97 beta6
- improved unlock for DCT4 (fbus/usb) to support 1600 5.03 direct unlock, also 1110, etc. No more downgrade.
- some bugs corrected
http://files.odeon.cn/JAF_Main_Softw...AF197beta6.rar
Regards
ODEON TEAM
Последний раз редактировалось uo5oq; 27.07.2006 в 19:38.
New JAF ver 1.97 beta7
--------------------------------------------------------------------------------
New JAF ver 1.97 beta7
- added corrected link to support server.
http://files.odeon.cn/JAF_Main_Softw...AF197beta7.rar
Regards
ODEON TEAM
New JAF Setup ver 1.97 beta8
--------------------------------------------------------------------------------
Hi
New JAF ver 1.97 beta8
- added full info on INF for BB5 fbus
- greatly improved DCT4 fbus local mode init and reading.
JAF box users must update firmware.
http://files.odeon.cn/JAF_Main_Softw...AF197beta8.rar
Regards
ODEON TEAM
New JAF Setup ver 1.97 beta9
--------------------------------------------------------------------------------
Hi
JAF ver 1.97 beta9
- rewritten DCT4 asic 2 imei patch routine. Now you can patch any dct4 asic 2 gsm phone without patch files. ESN NOT SUPPORTED YET. Hopefully in next days. Also some new versions of phones can be patched but no working signal, we work on that also. PHONES MUST HAVE WORKING IMEI BEFORE PATCH.
Some quick instructions:
1. Press imei patch. Enter new imei.
2. Select mcu file for that phone type and version.
http://files.odeon.cn/JAF_Main_Softw...AF197beta9.rar
Regards
ODEON TEAM
New JAF Setup ver 1.97 beta10
--------------------------------------------------------------------------------
New JAF 1.97 beta10
- added N93 flashing support USB and FBUS
- improved use ini function to support new flash pack
For N93 flashing you need Flash Loaders version 6.23.023 or higer.
Download from here http://files.odeon.cn/Flash6.23.023.rar
Also If you build your own fbus cable put 68k b/w bsi-gnd and 7.5k in serial with bsi line.
For USB flashing ONLY LIVE USB FLASHING IS POSSIBLE. When you flash by usb after flash phone takes long time to reboot. Even you have phone not found message but on phone display you have test mode then all is ok. Just reconnect phones battery and check the phone.
http://files.odeon.cn/JAF_Main_Softw...F197beta10.rar
Regards
ODEON TEAM